TSBs

Installing new Jeep striker plate

Feb. 6, 2024

This bulletin applies to 2017-2019 Jeep Compass vehicles equipped with Stop-Start Single VSM system.

Related To:

Remove the original striker plate from the hood.

This bulletin applies to 2017-2019 Jeep Compass vehicles built on or before Sept. 3, 2018, equipped with Stop-Start Single VSM system or Stop-Start Dual battery system.

Customers may experience a MIL on. The engine stop-start (ESS) may turn off with a message displayed in the cluster and will stay off while driving. DTC P152F may be set (engine hood switch two/engine hood switch one correlation).

Do not compress the striker pin before installation. Use a socket or other applicable tool to push the striker plate onto the hood.

Open and secure the hood. Using a trim stick or equivalent, remove the original striker plate from the hood and discard.

Install a new striker plate P/N 68417561AA. Note: the new striker plate has an installation and a locked position. DO NOT compress the striker pin before installation. Failure to do so will lock the striker plate and it will have to be discarded.

About the Author

Motor Age Staff

Motor Age has been publishing technical content for professional automotive technicians since 1899. Our writers have decades of experience and scores of ASE certifications, and they continue to teach new generations of technicians via classrooms all around the globe, as well as through the books and training manuals they've authored.