TSB: Chevy Coolant Flow

For specified Chevrolet vehicles, low coolant or trapped air may trigger P3075. Pressure-test for leaks, repair, bleed the system, and verify the diagnostic passes.

Chevy Coolant Flow

This bulletin applies to 2019 new model Silverado, 2019-2020 Blazer, 2020-2022 Silverado 1500, 2021-2022 Trailblazer and 2020-2022 Acadia vehicles equipped with a 1.3L, 2.0L or 2.7ZZL engine. The MIL may be on with DTC P3075 (engine coolant flow too low) set in the ECM. This may be caused by low coolant or air trapped in the cooling system.

  1. Pressure test the cooling system for leaks and repair as needed.

  2. Once leaks are resolved, bleed the cooling system per the service manual.

  3. After bleeding, clear codes and road test to completely purge any remaining air.

  4. The diagnostic test will run once per ignition cycle and will run the water pump at roughly 4000 rpm for 15 seconds and evaluates the pump motor AC current to be in the expected range. Code P3075/P3076 can detect coolant flow-based failures.

  5. The coolant pump AC current feedback will be lower if the cooling system is leaking or low in coolant.

  6. Using GDS, confirm that P3075 has run and passed in the current drive cycle to ensure that the diagnostic has executed and no fault is detected before releasing the vehicle.

Sign up for our eNewsletters
Get the latest news and updates

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!