Jeep: Roof Leak
This bulletin applies to 2021-2025 Jeep Wrangler and Gladiator vehicles built on or after Jan. 1, 2021, equipped with a 3-piece hard top. A water leak may exist from the top of the B-pillar when the vehicle is parked on a downward incline.
Perform a B-pillar water leak test. Raise the vehicle rear about 12 inches from the ground. Soak the entire roof area with water. Inspect both cabin B-pillars. If a leak is found, lower the vehicle and remove both Freedom panels and place them on a padded work surface. Ensure that the Freedom panels are dry and install the foam pads at the rear outer corner of both left and right Freedom panels.
- Foam, B pillar rear, right ... 68443146AA
- Foam, B pillar rear, left ... 68443147AA
Firmly press the foam pads on both panels to promote full adhesion. Verify that the interior is fully dry. Install the panels.