Replacing Jeep Gladiator fuel gauge

March 14, 2024
This bulletin applies to 2020 Jeep Gladiator vehicles equipped with a 3.6L V6 24V VVT engine.

This bulletin applies to 2020 Jeep Gladiator vehicles built on or after April 12, 2019, and on or before May 16, 2019, equipped with a 3.6L V6 24V VVT engine.

Owners may see the MIL on. They may note that the fuel gauge is not accurate or that the fuel gauge appears to be stuck. DTC P0461 (fuel level sensor 1 performance) may be set.

Replace the fuel tank using P/N 68332305AC and O-ring 55366298AA. Clear DTCs.

Sponsored Recommendations

Snap-on Training: ADAS Level 2 - Component Testing

The second video for Snap-on's comprehensive overview of Advanced Driver Assistance Systems (ADAS), covering the fundamental concepts and functionalities essential for automotive...

Snap-on Training: Intro to ADAS

Snap-on's training video provides a comprehensive overview of Advanced Driver Assistance Systems (ADAS), covering the fundamental concepts and functionalities essential for automotive...

Snap-on Training: Guided Component Tests Level 2

The second video for Snap-on's comprehensive overview of Guided Component Tests, covering the fundamental concepts essential for diagnostic procedures.

Snap-on Training: Data Bus Testing and Diagnosis Part 1

Learn the basics of vehicle data buses and their diagnosis with Snap-on's Jason Gabrenas.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!