Verify Adaptive Learning Procedures on Ford Explorer
This bulletin applies to 2011-2019 Ford Explorer vehicles. DTCs U2100 and U2101 indicate that the module has not been properly configured.
Check the repair history for any module replacement and verify all adaptive learning procedures were performed. Go to IDS>Toolbox>Module>Programming>As-Built>Select module.
When asked, “Were you sent here to obtain part numbers from another procedure”, answer “No” to configure the module.
About the Author
Information courtesy of Mitchell 1
Information for Technical Service Bulletins comes from ProDemand, Mitchell 1's auto repair information software for domestic and import vehicles. Headquartered in San Diego, Mitchell 1 has provided quality repair information solutions to the automotive industry since 1918.
Mike Mavrigian
Motor Age Editor
Mike Mavrigian has written thousands of automotive technical magazine articles involving a variety of specialties, from engine building to wheel alignment, and has authored more than a dozen books that crisscross the automotive spectrum. Mike operates Birchwood Automotive, an Ohio shop that builds custom engines and performs vintage vehicle restorations. The shop also features a professional photo studio to document projects and to create images for articles and books.