Some 2013-2014 Ford Flex vehicles equipped with a power liftgate and built on or before 9-9-2013 may exhibit a condition where the liftgate power open and/or close function is inoperative, or a crunching noise from the power liftgate motor is present during operation. DTC B2908 may be stored in the liftgate/trunk module (LTM).
Some 2013-2014 Ford Flex vehicles equipped with a power liftgate and built on or before 9-9-2013 may exhibit a condition where the liftgate power open and/or close function is inoperative, or a crunching noise from the power liftgate motor is present during operation. DTC B2908 may be stored in the liftgate/trunk module (LTM).
1. Is the power liftgate open and/or close function inoperative, or is there a crunching noise during operation?
2. No….this procedure does not apply. Continue normal diagnosis.
3. Yes…Proceed to Step 2.
4. Replace the power liftgate motor. Refer to the workshop manual, Section 501-03.
5. Perform the general procedure for liftgate alignment.
6. Reprogram the LTM to the latest calibration using IDS release 87.01 or higher.
The new liftgate motor is available as P/N DA8Z-14B351-A.
Learn how electronic parking brake actuators have replaced manual systems and now play a key role in advanced safety features like automatic emergency braking. This WIYB Training...
Not all fuel injectors are created equal. In this WIYB Training Series, we compare Standard® Fuel Injectors against OE, low-cost imports. See why precision engineering and rigorous...
Carrying active OEM subscriptions for all manufacturers is not possible for many shops. However, access to this software is required for certain modern vehicles and repairs, and...
Learn how to properly lubricate your AIRCAT air tools to keep them running at peak performance. Discover essential daily maintenance and storage techniques, along with the right...
Voice Your Opinion!
To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!
