VDO TPMS Sensor Has Rubber Snap-In Stem

Nov. 14, 2017
Continental Commercial Vehicles & Aftermarket offers its VDO REDI-Sensor TPMS sensor in a familiar, rubber snap-in stem design.

Continental Commercial Vehicles & Aftermarket offers its VDO REDI-Sensor TPMS sensor in a familiar, rubber snap-in stem design.

The sensor snaps together without any threaded components and follows the OE vehicle relearn procedures just like the original metal clamp-in VDO REDI-Sensor sensor.

All VDO TPMS sensors are OE-designed and validated, and they are ready to install right out of the box. No need for programming, training, cloning or special tools.

Sponsored Recommendations

Variable Valve Timing (VVT) Training Series

Almost every new vehicle is equipped with VVT technology. This video explains the weak points in OE designs and gives you a complete overview of the replacement options available...

Cam & Crank Sensor Training Series

Today's advanced engines depend on accurate and consistent information from cam and crank sensors for performance, fuel economy and emissions, and not all cam and crank sensors...

Buying Your Next Diagnostic Tablet

When you last invested in a diagnostic tablet for your shop, did you consider it a potential gateway to increased revenue? Probably not. It’s likely you viewed it as a necessary...

Access Carside OEM Repair Data with MOTOR TruSpeed

Now available on all Autel MaxiSYS Ultra Series tools, MOTOR TruSpeed Repair delivers expanded OEM service and repair data within days of being published by

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!