Nissan power steering hose change
Do not replace other related hoses unless necessary (do not replace as a set). Do not damage the pressure sensor during removal or installation. Always use a new O-ring when installing a new or existing pressure sensor. Pressure sensor mounting torque is 14.5 ft.-lbs. Always replace both copper washers (mounted at the power steering pump).
Do not allow dirt or contamination to enter the hydraulic system. Always secure the pressure sensor mounting block in a soft jaw vise when removing or installing. Do not clamp onto the banjo end of the hose.
PARTS INFORMATION
DESCRIPTIONÂ Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â HOSE W/SENSORÂ Â Â Â Â Â Â HOSE W/O SENSORÂ Â Â Â QTY
Hose & tube assembly……….49720-7S000                 49720-7S00A                 1
Copper washer……………….49726-Y0100                                                           2
O-ring seal……………………49345-6N200                                                           1
Pressure sensor……………….49763-6N20A                                                        1