Infiniti just won’t learn

July 29, 2013
This TSB applies to all 2007-2012 Infiniti vehicles in cases where the IAVL (intake air volume learn) will not complete when using CONSULT.

This TSB applies to all 2007-2012 Infiniti vehicles in cases where the IAVL (intake air volume learn) will not complete when using CONSULT.

A. While the engine is running, disconnect the MAF sensor for 10-15 seconds until the MIL illuminates (P0102 or P010C), and then reconnect the MAF before performing Intake Air Volume Learn.

NOTE: If the vehicle has two MAF sensors, disconnect only one in the prior step and leave the second one connected.

The engine may stop running when idle reduction occurs. Reconnect the MAF sensor and continue to Step B.

NOTE: If P0102 or P010C were not stored when DTC was checked, repeat Step A until idle is reduced.

B. Clear any DTCs that may have set during MAF disconnect.

C. Perform IAVL.

D. Confirm that idle is now within specifications for the model and year of the vehicle.

(Refer to the electronic service manual for the procedure to set IAVL and for idle specifications).

Sponsored Recommendations

Learn how electronic parking brake actuators have replaced manual systems and now play a key role in advanced safety features like automatic emergency braking. This WIYB Training...
Not all fuel injectors are created equal. In this WIYB Training Series, we compare Standard® Fuel Injectors against OE, low-cost imports. See why precision engineering and rigorous...
Carrying active OEM subscriptions for all manufacturers is not possible for many shops. However, access to this software is required for certain modern vehicles and repairs, and...
Learn how to properly lubricate your AIRCAT air tools to keep them running at peak performance. Discover essential daily maintenance and storage techniques, along with the right...

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!