Bad Threads and No-Start

Sept. 25, 2017
Some 2010-2012 Ford Escape models equipped with a 2.5L engine, built on or before 9-15-2011, may exhibit an intermittent no-crank, no-start condition with no DTCs or PATS indicator flashing.

Some 2010-2012 Ford Escape models equipped with a 2.5L engine, built on or before 9-15-2011, may exhibit an intermittent no-crank, no-start condition with no DTCs or PATS indicator flashing.

Remove the starter motor. Using a M10 x 1.5-6H tap, clean the threads of both starter motor bolt holes in the engine block to remove any excess material.

Clean the holes with compressed air.

Install the starter.

Sponsored Recommendations

Cam & Crank Sensor Training Series

Today's advanced engines depend on accurate and consistent information from cam and crank sensors for performance, fuel economy and emissions, and not all cam and crank sensors...

Buying Your Next Diagnostic Tablet

When you last invested in a diagnostic tablet for your shop, did you consider it a potential gateway to increased revenue? Probably not. It’s likely you viewed it as a necessary...

Access Carside OEM Repair Data with MOTOR TruSpeed

Now available on all Autel MaxiSYS Ultra Series tools, MOTOR TruSpeed Repair delivers expanded OEM service and repair data within days of being published by

ADAS Case Study: From 10 Calibrations a Month to Over 10 A Day

Originally published by Vehicle Service Pros, March 26, 2024

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!