Genesis Update

Nov. 25, 2019
This bulletin provides information related to an ECM software update to improve starting performance. Perform this update if a vehicle in in for service for an intermittent no-start concern. This applies to 2017-2018 Genesis G90 vehicles equipped with a 5.0 GDI engine.

This bulletin provides information related to an ECM software update to improve starting performance. Perform this update if a vehicle is in for service for an intermittent no-start concern. This applies to 2017-2018 Genesis G90 vehicles equipped with a 5.0 GDI engine.

Note that you must initially perform the GDS ECU update in Auto Mode. If the ECU update starts but then fails in Auto Mode, perform the update in Manual Mode to recover. If battery voltage is below 12 volts as per the GDS warning, select Back and operate the vehicle in Ready Mode for at least 20 minutes to ensure adequate battery state of charge. Turn the ignition back on and then retry the ECU update again.

1. Perform GDS software update.

2. Check for DTCs in all menus and erase any DTCs.

3. Erase the DTC in the BlueLink system and confirm normal vehicle operation

ECU P/N 39110-3FHN1:

OLD CALID: GHI-JN0GFS0-E200GHI-JN0GFS2-E200GHI-JN0GFF3-E200

NEW CALID:  GHI-JN0GFS3-E200

ECU P/N 39110-3FHN0:

OLD CALID: GHI-HN0GFS0-E200GHI-HN0GFS1-E200GHI-HN0GFS3-E200GHI-HN0GFF3-E200

NEW CALID:  GHI-HN0GFF4-E200

MANUAL MODE PASSWORD:

MENU HI5.0GDI39110-3FHN1............................. 1031

MENU HI5.0GDI39110-3FHN0............................. 1030

Sponsored Recommendations

Variable Valve Timing (VVT) Training Series

Almost every new vehicle is equipped with VVT technology. This video explains the weak points in OE designs and gives you a complete overview of the replacement options available...

Cam & Crank Sensor Training Series

Today's advanced engines depend on accurate and consistent information from cam and crank sensors for performance, fuel economy and emissions, and not all cam and crank sensors...

Buying Your Next Diagnostic Tablet

When you last invested in a diagnostic tablet for your shop, did you consider it a potential gateway to increased revenue? Probably not. It’s likely you viewed it as a necessary...

Access Carside OEM Repair Data with MOTOR TruSpeed

Now available on all Autel MaxiSYS Ultra Series tools, MOTOR TruSpeed Repair delivers expanded OEM service and repair data within days of being published by

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!