What is required to calibrate a blind spot radar after a collision?

Aug. 31, 2021
This case study on 2018 Subaru Forester shows the proper procedure, as well as how much trouble can be caused by a little sticker

This vehicle was hit in the rear and was repaired. During the repair, the blind spot radar units were removed and replaced. Due to their replacement, a calibration is required.

The calibration is done by making measurements from reference points on the ground that are made by suspending a plumb bob from reference points on the body.

The OEM calibration method is done by making measurements from reference points on the ground that are made by suspending a plumb bob from reference points on the body.​ You then measure from these points to set distances given by the OEM service information to place the proper recalibration target.

The Snap-on EZ ADAS and Tru Point use the latest technology such as lasers and/or camera positioning to accurately and quickly place the targets to OEM specifications.

By determining the intersection on the tape measures at the specified distance from the marked reference points, our calibration target placement can be established.  

Once our target is in place, we can begin the calibration. To do the calibration, the scan tool is connected to the car and the proper ADAS functional test is accessed to invoke the calibration.

It immediately fails on the driver's side, leaving us to try and determine what the issue is. Our first check is to go back and verify all of the reference points and measurements. We also want to make sure there are no nearby objects causing interference.​

After rechecking our setup, we decide to peel back the bumper covers and take a peek at the blind spot radar units to see if they are out of alignment. We notice that there is a sticker on the inside of the bumper cover, right in front of the radar sensor!​

Knowing that the radio waves emitted from these units can read through less dense materials like bumper covers, it seemed a little odd that a sticker could cause such an immediate and consistent failure - until we reached in and attempted to peel the sticker off, only to find a metallic "VOID" tamper sticker!​

We could not find any statement from Subaru stating that aftermarket bumpers must not be used. We were able to perform the calibration on the passenger side with no issues.

The shop removed the remaining sticker residue, and the calibration was completed successfully.

Sponsored Recommendations

ZEUS+: The Cutting-Edge Diagnostic Solution for Smart, Fast, and Efficient Auto Repairs

The new ZEUS+ simplifies your diagnostic process and guides you through the right repair, avoiding unnecessary steps along the way. It gives you the software coverage, processing...

Diagnostic Pre- and Post-scan Reports are Solid Gold for Profitability

The following article highlights the significance of pre-scans and post-scans, particularly with Snap-on scan tools, showcasing their efficiency in diagnosing issues and preventing...

Unlock Precision and Certainty: TRITON-D10 Webinar Training for Advanced Vehicle Diagnostics

The TRITON-D10 lets you dig deep into the systems of a vehicle and evaluate performance with comparative data, systematically eliminating the unnecessary to provide you with only...

APOLLO-D9: Trustworthy Diagnostics for Precision Repairs

The APOLLO-D9 provides the diagnostic information and resources you need to get the job done. No more hunting through forums or endlessly searching to find the right answers. ...

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!