From personal observations while working in the engineering world, I have found that it is not unusual for engineers to explain complex technical requirements in ways that are not easily understood. Service technicians have often developed their expertise logically without adequate instructions from the engineers, and this has led to difficulties.
Problems can occur if engineers fail to realize that deviations of maintenance procedures might occur in a manner they did not anticipate.
It remains for all engineers to be constantly aware that the instructions they develop might either be improperly presented or misunderstood.
It is also a primary responsibility for all engineers to monitor product deficiencies and to provide worthy assistance to maintenance providers whenever necessary.
None of us are perfect and mistakes will sometimes happen. So, when unforeseen problems do occur, it is necessary that everyone communicate effectively to resolve the issue.
Having designed wheel-end systems for highway trailers, and being exposed to numerous wheel separation accidents over the past 25 years, I am aware that it is a very complex situation.
Because there are some obvious problems that remain unattended, I feel compelled to make recommendations to reduce the frequency of problems associated with inappropriate adjustment of tapered roller bearings.
Within the engineering community dealing with wheel-end systems on commercial highway vehicles, there has been general agreement that elimination of "endplay" in favor of a slight amount of "controlled preload" would be an advantage. However, there is a lack of specific instructions from the axle and wheel-end component manufacturers advising how to install preload consistently within a recommended range.
Endplay is the degree of freedom that provides for a measurable amount of lateral movement of the hub assembly on the axle spindle. Preload is an amount of applied force against the tapered roller bearing by controlled adjustment of the spindle nut assembly to eliminate endplay.
There are some problems that can be satisfied with application of newly developed concepts and with enhanced information. Consider the following:
• There are axle nut components currently available that can be used to assemble wheel-end systems with controlled preload. However, there is a lack of specific instruction from the manufacturers advising how to install preload consistently within a recommended range.
For safety, it is my recommendation that attempts to adjust tapered roller bearings with preload not be made unless the manufacturer involved issues specific instructions for that purpose.
• At the present time, the Recommended Practices (RPs) published by the Technology and Maintenance Council (TMC) do not describe how "controlled preload" can be installed by service technicians. Rather, the RPs state that the component manufacturers of axles, bearings, oil seals and axle nuts should be requested to provide appropriate instructions.
• There has not been any definitive information published to inform those involved in commercial vehicle maintenance how wheel-ends should be inspected. Nor have those who are responsible for preventative maintenance been instructed on how often the wheel-end components should be disassembled and visibly inspected.
Recently, I conducted a survey among maintenance personnel associated with major fleet carriers. Among the purposes of the research was to evaluate the interest in an axle nut that is capable of installing a desired amount of preload. Survey respondents were in total agreement on three issues:
• Oil seal longevity can be increased with the elimination of endplay.
• Preload adjustment of tapered roller bearings will provide improved performance.
• Maintenance can be simplified with improved practices.
Research on controlled preload for tapered roller bearing adjustment.
Technical paper discusses acceptable preload for heavy duty vehicles operations